Saját EAGLE könyvtáram
Pillanatnyilag a következő alkatrészeket tartalmazza:

- 1N4933 dióda (x)
- AK5394 Super High Performance 192kHz 24-Bit ADC (x)
- ALC201 AC97 hangkártya
- CHIPSET_HEATSINK alaplapokon megtalálható hűtőborda 38x38mm
- DSUB25+9 alaplapokon található LPT és két sorosport kombinált csatlakozó
- HIP6601 félhíd meghajtó
- JACK_3.5 háromfeles jack aljzat
- L-EU egy tekercs
- LM2574 (x) kapcsolóüzemű stepdown
- LT1054
- MP8040 (x) komplett N fetes félhíd
- N- MOSFET n csatornás fet DDPAK és DPAK tokban
- TUSB5052 8051 alapú usb hub minden földi jóval
- USB2 dupla egymás feletti fekvő USB mama,
- HDSL3201 Irda adóvevő
- Siemens S55 Camera Siemens S55-ből kitermelt csatlakozó.
- Siemens S55 LCD lenyomat a fentebbi telefonból kitermelt LCDhez. (Tartalmazza a tartókeretet is.) Az LCD valószínűleg  a Leadis LDS181-en alapul.
- RouterStation az Ubiquiti Routerstation tetejére szerelhető panel lenyomata (USB, UART, GPIO, távtartók)
- SK1816 hall szenzor
-NE5044 7 csatornás PPM enkóder
-BA6418 Hhíd
-VS6502 kameramodul Alcatel OT555-ből

A könyvtárral kapcsolatos észrevételeidet kérlek
az alábbi címre írd meg:
martonmiklosqdev [ kukacc ] gmail < pötty > com
/* A [ kukacc ] részt cseréld @-ra
a < pötty >öt pedig .-ra */



A (x) -el jelölt alkatrészeket már élesben is voltak haszálva.
My EAGLE library
Which is contains the following parts:

- 1N4933 diode (x)
- AK5394 Super High Performance 192kHz 24-Bit ADC (x)
- ALC201 AC97 soundcard
- CHIPSET_HEATSINK 38x38mm heatsink (northbridge heatsink)
- DSUB25+9: a combined LPT and 2 serial connector.
- HIP6601 halfbridge driver
- JACK_3.5: 3.5 jack onnector
- L-EU: an inductor
- LM2574 (x) switching-stepdown
- LT1054
- MP8040 (x) complete halfbridge from N ch fets
- N- MOSFET N channel fets (D an DDPAK)
- TUSB5052 8051 based USB HUB with a lot of eyecandy
-USB2: two laying USB connectors. Mostly can found in motherboards.
- HDSL3201 Irda adóvevő
- Siemens S55 Camera Camera connector from an Siemens S55 cellphone
- Siemens S55 LCD footprint  (Including pad for the holding frame.) The LCD possibly based on Leadis LDS181.
- RouterStation : a base footprint for an addon card for the Ubiquiti Routerstation  ( including USB, UART, GPIO, and mounting screws pads.)
- SK1816 hall sensors
-NE5044 7 channel PPM encoder
-BA6418 H bridge
-VS6502 cameramodule from an Alcatel OT555

Any corrections, observations are welcome:
martonmiklosqdev [ at ] gmail < dott > com

/* replace the [ at ] part with @ and
the < dott > with . */




The parts marked (x) were used in a real design


martonmiklos.lbr

Utolsó módosítások (Changelog):
2010-02-27
VS6502 added

2010 - 02 -12
BA6418 added, fixed the RS NC pins direction

2010 - 01 -28
Removed GPIO2 pin from the Routerstation addon card, and fixed the GPIO port position


szamlalo